First Use Preparation And Set-Up - mspa ELITE Serie El Manual Del Propietario

REF. NO.
A
B
C
D
E
F
G
H
I
J
K
L
M
NOTE: When ordering parts, be sure to quote the model number and part numbers.

FIRST USE PREPARATION AND SET-UP

Site preparation and requirements
The spa can be installed indoors and outdoors. For household use only.
The spa must be set up on a flat, smooth, and firm surface that is capable of supporting the maximum load
of the filled spa with the listed number of maximum occupants.
Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can
damage the spa and void your warranty. Level the surface before filling the spa with water.
Provide adequate drainage system around the spa to deal with overflowing water and splashes.
Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
Additional requirements for indoor installation
qualified contractor or structural engineer to verify the requirement.
any other material that could be damaged by the moisture.
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
Spa tub
Wired controller
Digital lock (except for E-BL069)
Inflation hose
Filter cartridge set (twin pack)
Inflatable bladder
Spa drain valve adaptor
Wrench
Repair kit
Buckle spa cover and ground mat set
Instruction DVD
11
QTY.
1
1
1
1
1
1
1
1
1
1
1
1
1