Drainage, Cleaning And Storage - mspa ELITE Serie El Manual Del Propietario

usually use chlorine-based products and you want to switch to bromine-based products, or vice versa, it is
mandatory to completely change the spa water before any product changes.
sanitizing.

DRAINAGE, CLEANING AND STORAGE

Spa Drainage
1. Turn off all the buttons (heater, filter and bubble) on the wired controller.
2. Connect the drain valve adapter to a garden hose and point the other end of the garden hose to a suitable
draining area with local environmental regulations. (Fig.1)
3. Remove the drain valve cap from the outside of the spa tub and attach the drain valve adapter with the
garden hose to the drain valve. (Fig.2)
4. From the inside of the spa tub, open the drain valve cap, water will start flowing out through the garden
hose. (Fig.3)
5. When the water stops draining, lift the spa tub wall from the opposite to the drain, leading any remaining
water to the drain and empty the spa water completely. (Fig.4)
6. Press Bubble button to dry out any water in the piping system. Operate the bubbling function for 15
BUBBLE
minutes to blow out all the remaining water. (Fig.5)
7. When the water stops draining, use a clean towel to wipe up any remaining water and moisture on the spa
tub and spa control panel. (Fig.6)
1
garden hose
4
2
17
5
JET
21
3
6
15
minutes