Deleting The Data In The Measurement Memory - Welby BDH 612 Manual Del Usuario

Deleting the data in the measurement memory

2. If you push the "M" button for your desired memory again, "01" will appear
on the display. This is the last measurement. The display will then switch
to another indicator where the measurements and measuring time will be
shown as in Fig. 9.
3. If you push the "M" button again, "02" will appear on the display so that
the previous measurements are shown. By pushing one of the "M" buttons
again, you can access the following measurements.
Deleting the data in the measurement memory
− Once a measurement is complete or the device is in standby mode, hold the M1 or
9 7
M2 button /
the "CLR" symbol, which means that the saved measurements for "M1" and "M2" have
been deleted (see Fig. 10).
40
down for at least 5 seconds. The display
1
will now show you
Fig. 9
Fig. 10