Specific Safety Rules - ENAR QP Manual De Instrucciones

CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.
SERVICE
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the maintenance section of this manual.

SPECIFIC SAFETY RULES

1.- For the proper use of this device, please assure that the operator has been correctly informed of
the content of this manual before using it.
2.- This screed can be used only under the applications for which it has been designed and according
to these safety instructions.
3.- Do not touch any part of the vibrating group when the motor is running.
4.- Do not work in an area exposed to flammable liquids or gases.
5.- Do not allow inexperienced or not trained personal to use the poker alone.
6.- Always keep the vibrating screed clean and dry.
7.- Please secure all the threads and bolts before working.
8.- Do not stop the screed until the concrete mass is fully vibrated.
9.- Do not work with the screed if any type of dysfunction, even small, has been observed until repair.
10.- When working with a petrol screed:
- Read the motor manufacturer's manual before working.
- Do not work in closed rooms, the exhaust fumes may be toxic.
- Wait 2 minutes for the petrol refill until the motor gets colder.
11.- When working with an electric screed:
- Before connecting the motor to the power source, check that the Voltage and Frequency match the
en
specifications appearing in the plate.
- Make sure that the cables are of the correct section and are in good condition.
- If the screed is connected to a generator, please make sure the Output and voltage specifications
are the convenient ones for the model as showed in the specifications plate. The voltage must not vary
more than 5%.
- Install the cable fasteners supplied to avoid the cable is in the ground while working. These parts
are self-adhesive and must be placed as shown in the picture:
12.- The acoustic power level of this machine could be a risk for health (see table of characteristics at
point 2). Proper protective equipment must be used.
13.- Hand-arm vibration caused by machinery is a risk for health. The machine must always be
handled using isolated gloves and all the necessary safety equipment. Besides, the user must rest
each hour of effective work. Vibration levels for each type of double beam screed are shown in the
characteristics table of the point 2. The parts that isolate from vibrations must be always in good
condition. When they get damaged, replace them immediately.
FUTHERMORE, THE OPERATOR IS COMPELLED TO RESPECT ADDITIONAL REGULATIONS ENFORCED
6
EXTENSIBLE DOUBLE BEAM VIBRATING SCREEDS