HOMMELWERKE T500 Manual De Instrucciones página 71

Define memory capacity / erase memory
m d
Measuring run time delay
d
m
T500
With the DATA SAVE function switched-on,
the number of measurement-values (max.
125) can be pre-set. The number of decimal
places are selected as for the Tolerance
function. If more measurements are then
carried out than have been pre-set, the
saved values will not be affected.
jÿ
Note: With older software versions than
1.22, resetting the memory (i.e. erasing all
saved values) is carried-out with the SAVE
function. Change any decimal point of the
previously set SAVE value.
A measuring run time delay of between 1 and
9 seconds can be set. This enables the
HOMMEL TESTER T500 to be positioned
securely before the measurement is taken.
WAIT OFF : Time-delay deactivated
2 Operation
29