Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Read and understand the safety
chapter before you operate the product.
Fuel
To use fuel
CAUTION: This product has a two-cycle
engine. Use a mixture of gasoline and two-
cycle engine oil. Make sure to use the
correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
Gasoline
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). This
can cause damage to the product.
•
Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
•
Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
Two-cycle engine oil
•
Use only high quality two-cycle engine oil. Use only
an air cooled engine oil.
•
Do not use other types of oil.
•
Mixture ratio 50:1 (2%)
Gasoline
1 U.S. Gal.
1 UK Gal.
5 l
To make the fuel mixture
Note: Always use a clean fuel container when you mix
the fuel.
Note: Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
226 - 004 - 17.10.2018
OPERATION
Oil
77 ml (2,6 oz)
95 ml (3,2 oz)
100 ml (3,4 oz)
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
•
Always use a fuel container with an antispill valve.
•
If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
•
Make sure that the area near the fuel tank cap is
clean.
•
Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
Before you start the engine
•
Examine the product for missing, damaged, loose or
worn parts.
•
Examine the nuts, screws and bolts.
•
Examine the air filter.
•
Examine the throttle trigger lockout and the throttle
control for correct operation.
•
Examine the stop switch for correct operation.
•
Examine the product for fuel leaks.
•
Examine the saw chain sharpness and tension.
To start a cold engine
1. Set the product on a flat surface.
2. Push the primer bulb 6 times.
3. Move the start lever to the start position.
Note: Do not squeeze the throttle trigger.
4. Hold the body of the product on the ground with your
left hand. Do not step on the product. Pull the starter
rope handle slowly until you feel some resistance.
(Fig. 36 )
5. Pull the starter rope handle until the engine starts
and runs.
CAUTION: Do not pull the starter rope
until it stops. Do not let go of the starter
rope when it is fully extended. Release
the starter rope slowly. Failure to obey
these instructions can cause damage to
the engine.
6. Let the engine run for 10-15 seconds.
7. Fully squeeze the throttle trigger to disengage the
starting system.
15
Publicidad
Capítulos
Tabla de contenido
