Care And Cleaning; Grease Filter; Charcoal Filter - Faber 152 Manual De Instrucciones

CARE AND CLEANING

GREASE FILTER

Regular maintenance and cleaning will ensure good
performance and reliability, while extending the work-
ing life of the hood. Special attention should be taken to
keep the grease filter clean at all times and the charcoal
filter (recirculation model) should be replaced regular-
ly. To remove filters for subsequent cleaning and re-
placement first open the metal grille panel.
This retain the solid grease particles. It is fitted onto the
reverse side of the lower grille panel and can be either
of a synthetic material or metallic. Maintenance of the
grease filter varies according to the type used: synthetic
grease filters should not be washed and should be re-
placed every three months. The metal grease filters
should be washed once a month in hot water using mild
detergent or liquid soap. It should not be bent and
should be left to dry before being refitted. The filter is
easily removed from grille by pushing the spring wire
clips to one side and removing.

CHARCOAL FILTER

In the recycling mode the charcoal filter absorbs smells
and odours. The charcoal filter cannot be cleaned and
should be replaced at least every six months or more
frequently if the hood is used consistently.
To replace the charcoal filter, support the filter with one
hand, remove the round disk through the centre of the
charcoal filter and rotate it till the filter will come away.
Replace by reversing the operation.
WARNING! It is a possible fire hazard if the filters
are not cleaned and replaced as recommended.
CLEANING
The metalwork should be cleaned regularly, at least once a month, using household cleaners
and polish. Never use abrasives.
10
EN 10