Care And Cleaning; Cleaning The Filters - Faber CYLINDRA ISOLA Manual De Instrucciones

CARE AND CLEANING

REMOTE CONTROL (OPTIONAL)
This appliance can be commanded using a remote control, powered by
a CR2032 type 3 V battery (not supplied).
• Do not place the remote control near heat sources.
• Do not discard the batteries with normal waste, they must be put into
the specific containers.
These can be washed in the dishwasher, and need to be cleaned
whenever the S1 Led comes on or at least once every 2 months
use, or more frequently if use is particularly intensive.
Resetting the alarm signal
• Turn the Lights and the Suction Motor off.
• Press T3 and hold for at least 3 seconds, until LED flashes
three times in confirmation.

Cleaning the Filters

• Open the lighting unit by pulling on the nocth.
• Remove the Filter, pushing it towards the back of the unit and
at the same time pulling downward.
• Wash the filter without bending it, and leave it to dry
thoroughly before replacing (if the surface of the filter changes
colour over time, this will have absolutely no effect on its
efficiency).
• Replace, taking care to ensure that the handle faces forwards.
• Replace the lighting unit.
EN
Metal grease filters
CLEANING THE FILTERS
1
14