Care And Cleaning - Faber SKYLIFT BK F110 Manual De Instrucciones

where you purchased the
product.
2. USE
• The extractor hood has been designed
exclusively for domestic use to eliminate
kitchen smells.
• Never use the hood for purposes other
than for which it has been designed.
• Never leave high naked flames under
the hood when it is in operation.
• Adjust the flame intensity to direct it onto
the bottom of the pan only, making sure
that it does not engulf the sides.
• Deep fat fryers must be continuously
monitored during use: overheated oil
can burst into flames.

3. CARE AND CLEANING

- The anti-odour filter can be rege-
nerated every 3-4 months (or more
frequently if the hood is subject to
intensive use) (W).
- Regeneration procedure:
Put the anti-odour filter in the oven
on air circulation mode at a Max
temperature of 250° for 1 hours.
The Minimum temperature is 150°.
The higher temperature the shorter
the regeneration time.
W
- The Grease filters must be cleaned
every 2 months of operation, or more
frequently for particularly heavy usage,
and can be washed in a dishwasher (Z).
• Clean the hood using a damp cloth and
a neutral liquid detergent.
4. CONTROLS
L
Button Function
L Turns the lights On/Off.
T1 Hood Down
Press for 2 seconds to raise
the Hood.
Press briefly to turn the Motor
On/Off.
Hood Up
Press once: The Hood lowers.
Press a second time: The
Hood Stops.
When the movement has
been completed the motor
turns on at Speed two.
The electronic control system recognises and
signals two types of fault
Led T1
Slow flashing Current absorption threshold exceeded:
If an overload condition occurs, the fault
is signalled by LED T1 on the keyboard
flashing once every 2 seconds. Check
that nothing is blocking normal hood
movements.The signal remains active until
a new hood open/close command is given.
Rapid Hood opening safety microswitch
flashing tripped:
If the safety microswitch trips, the fault
is signalled by LED T1 on the keyboard
flashing quickly (once every 250 ms).
This means that the hood has passed
the microswitch........ Call Technical
Assistance!
You can continue to use the hood's light
and motor functions while this fault is
active. Whenever the motor is on, LED
T1 will continue to flash, indicating that
the fault is still present.
T1 T2 T3
Display
-
On/Off
Off/Off
S1
T4
5