Maintenance Measures; Environmental Protection - KRESS WTS 900 E Instrucciones De Servicio

WTS 900 E
9 Practical Tips
Rough Grinding (Fig. D)
The best grinding results can be obtained by working
at an angle of incline of approx. 20° – 30°.
Cutting
For cut-off grinding, you should work using moderate
pressure and not tilt the cutting disc.
The machine must run in the opposite sense so that it
is not pressed out of the cut.

10 Maintenance Measures

Before any work on the machine itself, pull the
mains plug!
Always keep the ventilation slots clean.
Wipe off the accessible plastic parts regularly with a
cloth without cleaning agent.
After heavy use over a long period, the machine
should be taken to a Kress service location for an
inspection and thorough cleaning.
11 Auxiliaries
Auxiliaries supplied with the machine
– 1 face spanner

12 Environmental Protection

Kress takes back worn-out machines
for the purpose of resource-saving
recycling. As a result of their modular
construction, Kress machines can be
very easily dismantled into their reusa-
ble materials.
Give your worn-out Kress machine to your dealer or
send it directly to Kress.
Subject to change without notice
English
11