Sanyo SPW-XDR74GXH56 Manual De Instrucciones página 16

I: FLAP button
NOTE
(SWEEP)
NOTE
J: TIMER SET button
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
K: Time setting buttons
L: SET button
M: CL button
N: VENTILATION button
O: Remote control sensor
NOTE
16
Parts Name and Functions (continued)
1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
Operation mode
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
• In the cool mode and dry mode, if the flaps are set in a downward position,
condensation may form and drip around the vent.
• Do not move the flap with your hands.
This function is available only for models X, LD, S, T and K.
2. Use this button to make the airflow direction sweep up and down automatically.
Press this button several times until the
To stop the swing operation
Press the FLAP button again during the flap swing operation to stop the flap at the desired
position. Then, the airflow can be set from the top position by pressing the FLAP button again.
Indicator when swing operation is stopped
Fan and heating
During cooling and drying, the flap does not stop at the downward position. Even if the flap is
stopped at the downward position during the swing operation, it does not stop until it moves to
the third position from the top.
This function is available only for models X, LD, S, T and K.
Use this button while the unit is operating to switch between timer settings.
: The air conditioner stops after a preset time elapses.
:The air conditioner always stops after a preset time elapses.
: The air conditioner starts after a preset time elapses.
: Press this button to increase the time.
: Press this button to decrease the time.
Use this button to set the timer.
Use this button to clear the timer setting.
This is used when a ventilation fan (available commercially) is connected. Pressing the
VENTILATION button turns the fan on and off. The ventilation fan also turns on and off when
the air conditioner unit is turned on and off. (The display of the remote control unit shows
" " while the ventilation fan is running.)
* If " " is shown on the display of the remote control unit when the VENTILATION button is
pressed, this indicates that the ventilation fan is not connected.
Normally, the temperature sensor of the indoor unit is used to detect the temperature.
However, it is also possible to detect the temperature around the remote control unit.
For details, contact the dealer where you made the purchase.
(Do not set when using group control.)
1) When two remote control units are being used in one group control* system,
a) the most recent button that is pressed on any remote control unit is effective.
b) either a main-remote control unit or a sub-remote control can set the timer.
* Group control means that maximum up to 8 indoor units can be concurrently
controlled with a remote control unit.
2) If a power failure occurs in timer mode, the time counted up to that point will be stored in
memory.
After power is restored, the timer starts again counting up to the set time.
Number of airflow direction settings
3
5
3
5
symbol appears on the display.
Cooling and drying
OI-751-16-EG