Wireless Remote Control Unit (Optional Parts); Parts Name And Functions - Sanyo SPW-XDR74GXH56 Manual De Instrucciones

E: FAN SPEED selector button
J: TIMER SET button
K: Time setting buttons
NOTE
A: ON/OFF operation
button
B: Transmitter
C: MODE button
(AUTO)
(HEAT)
(DRY)
(COOL)
(FAN)
D: Temperature setting
buttons
E: FAN SPEED selector
button
(AUTO)
(HI.)
(MED.)
(LO.)
F: FILTER button
4

Wireless Remote Control Unit (Optional parts)

Parts Name and Functions

C: MODE button
L: SET button
M: CL button
P: ACL button
(ALL CLEAR)
The illustration above pictures the wireless remote control unit after the cover has been
lowered and removed.
This button is for turning the air conditioner on and off.
When you press the buttons on the wireless remote control unit, the
display to transmit the setting changes to the receiver in the air conditioner.
Use this button to select one of the following five operating modes.
: Used to automatically set cooling or heating operation. Only for single heat pump type
: Used for normal heating operation. Only for heat pump type
: Used for dehumidifying without changing the room temperature.
: Used for normal cooling operation.
: Used to run the fan only, without heating or cooling operation.
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
If a separately installed signal receiver is being employed, this button is used to turn off its
filter lamp. When the filter lamp has lighted, first clean the filter, and then press the FILTER
button to turn off the filter lamp.
When a wired remote control unit and wireless remote control unit are both used, the filter sign
on the wired remote control unit will be appeared. When this happens, first clean the filter, and
then press the FILTER button on one of the remote control units to turn off the filter sign.
B: Transmitter
O: Remote control sensor
A: ON/OFF operation button
D: Temperature setting buttons
I: FLAP button
G: ADDRESS button
F: FILTER button
N: VENTILATION button
H: A/C SENSOR button
Q: Slide switch
mark appears in the
(temperature range: 17 to 27°C)
(temperature range: 16 to 26°C)
(temperature range: 18 to 30°C)
(temperature range: 18 to 30°C)
OI-751-4-EG