Steering; Tires; Gearbox; 29.7.1 Check Gearbox Oil - Zipper Maschinen ZI-RD300 Manual De Instrucciones

29.5

Steering

If you have difficulty steering the unit, you will need to adjust the steering levers with the special
adjusters.
If the above adjustment does not create enough cable tension, follow the steps below:
29.6

Tires

Check the pressure of tires periodically to make sure they are properly inflated.
Recommended pressure is: 2,1 bar (0,21Mpa)
29.7

Gearbox

29.7.1 Check gearbox oil

The gearbox is pre-lubricated and sealed at the factory. Unless there is evidence of leakage or service
has been performed on the gearbox, no additional lubricate should be required until 50 hours of use.
For future use, check the oil level after every 50 hours of use.
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
If you remove the oil level plug and no oil flows out, please add oil and then screw the oil level plug.
NOTICE: recommended motor oil: GL-5, GL-6, SAE80W-90. Do not use synthetic oil!
If you want to replace oil, place the machine on a level ground. The machine must be stopped and
still warm. Unscrew the filter cap and the drain plug. When the oil is drained, replace the drain plug,
fill up with fresh oil and then replace the filter cap.
29.8

Storage

If the machine is stored for longer than 30 days:
• Let the machine cool down
• Clean the machine and dry
• Empty Tank and carburetor completely, avoid fuel spillage
• Store in a dry, out of reach of children place, well packaged
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RD300
1. Loosen the jam nut (3) by turning it counter clockwise with 10
mm wrench.
2. Unscrew the adjust nut (4) to eliminate the play in the cable,
which can occur after initial use or normal wear. Be very careful
not to unscrew the adjust nut too much because this can create
another problem: the loss of traction.
3. Then retighten the lock nut (3).
1. Loosen the jam nut (5) by turning it counter clockwise with 10
mm wrench.
2. Unscrew the adjustment nut (6) to eliminate the play in the
cable. (do not to unscrew the adjust nut too much because this
can create another problem: the loss of traction).
3. Retighten the lock nut (5).
NOTICE
MAINTENANCE
36