If an application is sending or receiving data using a packet data connection, end
the application before you use voice dialing.
Voice commands are language-dependent. To set the language, see Voice playback
language in "Phone," p. 73.
Note: Using voice tags may be difficult in a noisy environment or
during an emergency, so you should not rely solely upon voice dialing
in all circumstances.
1. In the standby mode, press and hold the right selection key, or press and hold
the volume down key. A short tone sounds, and Speak now is displayed.
If you are using a compatible headset with the headset key, press and hold the
headset key to start the voice dialing.
2. Say the voice command clearly. If the voice recognition was successful, a list with
matches is displayed. The phone plays the voice command of the match on the
top of the list. After about 1.5 seconds, the phone dials the number; or if the result
is not the correct one, scroll to another entry, and select to dial the entry.
Using voice commands to carry out a selected phone function is similar to voice
dialing. See Voice commands in "My shortcuts," p. 65.
■ Answer or decline a call
To answer an incoming call, press the call key, or open the phone. To end the call,
press the end key, or close the phone.
To decline an incoming call if the phone is open, press the end key. To decline an
incoming call when the phone is closed, press and hold a volume key.
To mute the ringing tone, press a volume key when the phone is closed, or select
Silence when the phone is open.
All manuals and user guides at all-guides.com
C a l l f u n c t i o n s
27