Michelin 12V Instrucciones De Uso página 10

GB
5. Wait a few seconds until display on digital tyre pressure gauge shows
"0 BAR".
6. Screw the thumb lock connector to the tyre valve. When connected the
gauge will display the current pressure in the tyre.
7. Switch on the "0/1", position '1', the compressor will inflate the tyre.
IMPORTANT : Never remove the digital tyre pressure gauge during inflation of
your tyres. If you accidentally do, switch the compressor off , unscrew tyre valve
adaptor from tyre valve and restart as from point 1.
8. You will now show the pressure increasing on the gauge.
9. Switch off the "0/1", position '0, to stop the inflation. Due to the sensitive
nature of the tyre pressure measuring system, you may find that when you
switch the tyre inflator off at the required pressure the gauge may drop
back slightly. If it happens, switch back on and inflate to a slightly higher
pressure. Switch off and re-check.
10. If you overinflate, press the deflate bleed valve button to release air until
gauge shows correct pressure.
IMPORTANT !
Allow inflator to cool for 10 minutes after each 10 minutes of continuous use.
10