Assemble The Platter System; Connect And Start Djing - Denon DJ SC5000M PRIME Guia Del Usuario

Setup

1. Assemble the Platter System

1. Remove the SC5000M base from the packaging. Remove the platter assembly from the package
(underneath SC5000M). Place SC5000M on a flat, stable surface for assembly and operation.
2. Place the platter onto the SC5000M base by aligning the pins in the bottom of the
platter with the holes in SC5000M's motor. Press it down firmly. Check to make sure
that it rotates uniformly and does not wobble excessively.
3. Place the slipmat onto the platter, then place the vinyl over the slipmat.
4. Line up the notch in the spindle with the screw in the spindle lock adapter. Use the allen
wrench (included) to tighten the screw, locking the adapter to the spindle.
Note: By pressing down on or lifting up the vinyl while you tighten the spindle screw,
you can adjust the slip friction to your preferred feel.

2. Connect and Start DJing!

1. Make sure all of your devices are powered off or all of their volume levels are at their minimum positions.
2. Connect SC5000M Prime's audio outputs (Layer A/B or Digital Outputs A/B) to the inputs of your
mixer.
3. Connect SC5000M Prime's Link ports according to one of the following connection diagram examples.
4. Connect any output devices (turntables, headphones, power amplifiers, loudspeakers, etc.) to the outputs of
your mixer.
5. Connect all of your devices to power sources.
When starting a session, power on (1) SC5000M Prime and other input sources, (2) your mixer, and then (3)
output devices.
When ending a session, power off (1) output devices, (2) your mixer, and then (3) SC5000M Prime and other
input sources.
4