Pad Modes - Denon DJ SC6000 PRIME Guia Del Usuario

Syncing & Pitch Adjustment
To activate sync, press Sync on the unit that you want to control the BPM, which becomes the "master." After
Sync is activated on that unit, press Sync on any additional units. The tempo of each unit will immediately
synchronize to match the tempo of the master unit.
The Sync state icon in the display will indicate the current status:
•
Sync Off: Sync is deactivated.
•
Tempo Sync: Only the tempo is synced (the BPM will match that of the master unit).
•
Beat Sync: The tempo will be synced, and the track will be automatically beat-matched with the track on
the master unit.
To deactivate sync on an SC6000 PRIME unit, press Shift+Sync.
To set a different SC6000 PRIME unit as the master, press Master. All connected SC6000 PRIME units with
Sync activated will use the tempo of this unit.
To adjust the track's pitch, move the pitch fader. You can do this only when the deck is not synced.
Important: If Sync is activated, moving the pitch fader on the "master" SC6000 PRIME unit will change the
speed of all synced units, while moving the pitch fader on other units will do nothing.
To adjust the track's pitch momentarily, press and hold one of the Pitch Bend –/+ buttons.
To adjust the range of the pitch fader, press and hold Shift and press one of the Pitch Bend –/+ buttons to
select +4%, 8%, 10%, 20%, 50%, or 100%.
To reset the track's pitch to 0%, press Shift+Key Lock/Pitch Reset. The track's pitch will return to its original
pitch (0%) regardless of the position of the pitch fader.
To adjust the track's key, tap the key on the touchscreen to open the Key Change Menu.

Pad Modes

The 8 pads have different functions in each pad mode. The Parameter / buttons will make adjustments specific to
each pad mode.
To enter each pad mode, press the corresponding button: Hot Cue, Loop, Roll, or Slicer.
Hot Cue Mode
In Hot Cue Mode, you can use each pad to jump to an assigned hot cue point.
Tip: You can use the Engine Prime software to set, name, and assign colors to your hot cue points. The names
and colors will appear in the display for reference.
To assign a hot cue to a pad, press a dimly lit pad at the desired location in the track. The pad will light up when
a hot cue point is assigned.
To jump to a hot cue point, press the corresponding pad.
To clear a hot cue from a pad, press Shift and the desired pad. The pad will turn off when there is no hot cue point
assigned to it.
14
Hot Hot Hot
Cue 1 Cue 2 Cue 3
Hot Hot Hot
Cue 4 Cue 5 Cue 6
Hot Hot
Cue 7 Cue 8