Denon DJ SC6000 PRIME Guia Del Usuario página 15

Loop Modes
In Manual Loop Mode, you can use each pad to activate an assigned loop. Pressing Loop for the first time will
always enter Manual Loop Mode.
Tip: You can use the Engine Prime software to set and name your loops. The names will appear in the display for
reference.
To assign a loop to a pad and activate it, press a dimly lit pad to create a Loop In point at the current
location, and then press it again to create the Loop Out point at another location. You can also assign an
auto loop to a pad by pressing a dimly lit pad while in the auto loop. The loop will activate immediately, and
the pad will light up.
To activate a loop, press the corresponding pad.
To delete a loop, press Shift and the desired pad.
In Auto Loop Mode, you can use each pad to create and activate an auto loop. Pressing Loop while in Manual
Loop Mode will enter Auto Loop Mode.
To activate an auto loop, press a pad. The display will show the length of the auto loop for each pad.
To deactivate an auto loop, press the pad again.
Roll Mode
In Roll Mode, you can press and hold each pad to trigger a "loop roll" of a certain length while the track's timeline
continues (the lower half of the waveform in the display will continue moving forward). When you release the pad, the
track will resume normal playback from where it would have been if you had never done anything (i.e., as if the track
had been playing forward the whole time).
To trigger a roll, press the corresponding pad. Pads with triplet-based loop rolls are lit purple.
Slicer Mode
In Slicer Mode (first press), the 8 pads represent 8 sequential beats—"slices"—in the beatgrid. The currently
playing slice is represented by the currently lit pad; the light will "move through the pads" as it progresses through
the 8-slice phrase. You can press a pad to play that slice. When you release the pad, the track will resume normal
playback from where it would have been if you had never pressed it (i.e., as if the track had been playing forward
the whole time).
In Slicer Loop Mode (second press), you automatically activate an 8-beat loop. The currently playing slice is
represented by the currently lit pad; the light will "move through the pads" as it progresses through the eight-slice
phrase, which will loop (this is the difference between this mode and Slicer Mode). You can press a pad to play
that slice. When you release the pad, the track will resume normal playback from where it would have been in the
loop if you had never pressed it (i.e., as if the track had been playing forward the whole time).
To play a slice, press the corresponding pad.
Loop
1
(T denotes a triplet-
1/8-Beat
based time division)
Roll
Slice
1
Loop Loop Loop
2 3 4
1/4T-Beat 1/4-Beat 1/2T-Beat
Roll Roll
Roll
Slice Slice Slice
2 3 4
Loop Loop Loop
5 6 7
1/2-Beat 1T-Beat 1-Beat
Roll
Roll Roll
Slice Slice Slice
5 6 7
Loop
8
2-Beat
Roll
Slice
8
15