Removing The Presser Foot; Attaching The Presser Foot; Adjustment Of Presser Foot - ALFA COVER Style Manual De Instrucciones

3
2
�

Removing the Presser Foot

1. Turn off the power switch and unplug the machi ne.
2. Turn the balance wheel toward you to raise the
needle.
Raise the presser foot.
3. Press the lever located on the back of the foot
holder. The presser foot will drop off.
CD salance wheel @ Lever @ Presser holder

Attaching the Presser Foot

1. Turn off the power switch and unplug the machi ne.
2. Place the presser foot so that the pin on the foot
lies just under the groove of the presser holder.
3. Lower the presser holder to lock the foot into
place.
4. Raise the presser bar connection rod to check that
the presser foot is secure.
CD Presser holder @ Groove @ Pin
Adjustment of Pressure Foot
The preset presser foot pressure on the machi ne is
su ita ble far medium fabrics. Far most fabrics, the
presser foot pressure does not need to be altered. lf
you intend to work with lighter or heavier fabrics,
however, it may be necessary to reset the pressure.
In this case, you can choose from six position; make
your selection with the presser foot pressure
adjustment knob. The standard setting is "N".
CD Presser foot Pressure
29