Tristar SZ-2187 Manual De Usuario página 6

Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz
This vacuum is not designed to collect liquids and sharp. Never vacuum hot ashes, make sure
it is fully cooled.
First use
Place the vacuum foot (No 15) on the telescope tube (nr.7). The telescope tube length can be
made, according to your wishes, by the pressing button (nr.6) down and push the tube to
extend or reduce. Place the tube (Nr.10) with the side of the hose coupling (nr.5) in front of the
vacuum, if you hear a click, this just confirmed. To disconnect the hose press the button of the
hose coupling.
Using the button on the vacuum foot in the desired position, with or without a brush on the
bottom of the suction foot. With the air regulator (nr.8) controls the suction if it should be
temporarily reduced.
Use
Pull the plug from the vacuum cleaner and place it into a wall outlet. Press the ON / OFF
button and start your vacuum cleaner line to the suction button (nr.2) the desired suction.
With the air regulator (nr.8) controls the suction if it should be temporarily reduced.
To turn the unit off, press the ON / OFF button. Unplug the power cord and press the button
cable rewind (nr.3). You can use the storage clip (nr.14) to store the vacuum bar when you
store the vacuum cleaner.
Cleaning of the device
You need to empty the dust container when the dust full indicator light (No 4) lights.
Do this immediately otherwise it loses much suction device.
Press the button of the dust collector as
Figure B and remove it from the device.
Hold the container over a dust bin
and press the button at the bottom of the dust
collector. See Figure C.
Close the lid and place the dust collector
back into the device until you hear a click.
11
UK
To ensure the best suction of the vacuum cleaner you have to cleanthe HEPA filter (Nr.12)
regular. Remove the dust container from the device (Figure B). Turn the lid counter-clockwise
independently, see Figure D.
Remove the HEPA filter 12 from the dust container by turn the dust container back cover
anticlockwise. see Figure E. Clean the filter and the various parts with lukewarm water. These
parts are not dishwasher safe.
Make the good parts dry, let the filter dry completely before you put it back.
Remove the cover on the back of the device and remove the filter, see Figure E1.
Clean the filter and cover with lukewarm water, allow the parts to dry completely before you put
it back. The vacuum cleaner and the other parts you can use a damp cloth to decline.
Never use the vacuum with a wet filter! This may cause an electric shock and
the unit may malfunction.
12