Ventilation System - X-LITE X 502 Ultra Puro Seguridad E Instrucciones

- Remove the side hose clip and fold back the "READY FOR CAMEL BAG" strap
if a hydration system is not used.
- Fasten the side hose clip only to the "READY FOR CAMEL BAG" strap.
- Do not fasten the side hose clip to the cheek pads and/or removable padding.
- Do not modify or tamper with the helmet components to install the hydration
system. Check that the hydration system hose is compatible with the hose clip
and deformable seat of the chin guard.
- In case of doubt, malfunctioning or damage, please contact an X-Lite author-
ized dealer.

VENTILATION SYSTEM

The ventilation system of the helmet (Fig. 24) consists of:
Upper air intakes:
air, directing it dispersion-free in the upper area of the rider's head.
Front air intakes:
located under the peak capture and channel the air, directing it dispersion-free in the
front area of the rider's head. Another two openings are in the front area, near the
sealing edge of the window opening.
Chin guard air intake:
tent.
Air extractors: located on the upper rear part of the helmet, in line with the rear base
edge and on the sides of the helmet so that warm and stale air can flow out, thus
ensuring optimum comfort inside the helmet.
CHIN GUARD AIR INTAKE FILTERS
The chin guard air intake is fitted with a fixed external filter in metal mesh that allows
easy air intake while limiting the entry of insects or small stones, and a second re-
movable internal filter assembled in the inner chin guard that can be removed from its
housing to increase the flow rate of the air intake and/or to be washed.
19. Disassembly of the removable internal filter
To remove the removable internal filter, pry its holding frame towards the inside of the
helmet near the upper right corner of the frame. Unfasten the holding frame from the
deformable internal chin guard by slipping the fastening flaps out of the slots on the
internal chin guard.
Completely remove the holding frame from the chin guard and pull the filter out from
its housing in the internal chin guard.
Then reassemble the filter holding frame on the internal chin guard by inserting, one
by one, the side and then upper fastening flaps of the frame in the corresponding
slots on the internal chin guard applying light pressure above (Fig. 25).
the two openings located under the peak capture and channel the
also with the contribution of the side conveyors, two openings
provides ventilation in the mouth area while filtering its con-
23