Publicidad
Idiomas disponibles
Idiomas disponibles
Connection
m
CAUTION
The appliance is supplied with a fitted plug and may be
connected to a correctly installed earthed socket only
(NEMA 5-15R, 125 V, 15 A, 2 Pole 3-wire Grounding).
Only an electrician may fit a socket or replace the power cord
in consideration of the relevant regulations. Only an
appliance which has been correctly installed according to
these installation instructions can be used safely.
Attach loose cabinets to the wall with a conventional bracket.
Included in standard delivery
1
Fig.
a Chassis (with telescopic slides)
b Support plate with appliance and front panel
c Wood screws (6x)
d Self-tapping screws (2x)
e Bar
f
Fastening screws (2x)
g Cable holder
Installing the appliance
CAUTION
To avoid overheating and burn hazard all specified
clearances must be observed.
2
Fig.
The built-in unit must not have a rear panel behind the
appliance.
There must be a gap of at least 1
the wall and base of the unit or the rear panel of the unit
situated above.
The ventilation slots and intake openings must not be
covered.
Also follow the installation instructions for the appliance
situated above or below.
If installing the appliance above a warming drawer, the height
of the recess must be 27
If the appliance is installed directly under a decor panel,
ensure that there is a ventilation slot of at least
31 square inch (200 cm²).
The ideal installation height for the fully automatic espresso
machine, measured from the floor to the lower edge of the
1
appliance, is 37
/
inch (950 mm).
4
3
/
inch (45 mm) between
4
7
/
inch (590 mm).
16
̨
First unpack all parts according to the instructions
and check for damage in transit.
Do not switch on a damaged appliance.
3
Fig.
̨
Place the bar e under the top of the chassis a and
screw on with the screws f.
4
Fig.
̨
Then attach the chassis a, centred and flush at the
front, with the enclosed 6 screws c.
5
Fig.
̨
Pull out both telescopic slides.
̨
Place the support plate b with the appliance on the
two telescopic slides.
Secure with the pre-assembled screws d.
̨
Insert the plug and clamp the coiled cable in the cable
holder g.
2
Publicidad
