Control Panel - Zanussi ZFU319EW Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
• This product must be serviced by an authorized Service
Centre, and only genuine spare parts must be used.
Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be

Control panel

1
2
1
Green On/Off Indicator Light
2
Temperature Regulator and On/Off Switch
3
Yellow Fast Freeze Indicator Light
4
Acoustic Signal Stop and Fast Freeze Switch
5
Red Alarm Indicator Light
Switching on
1. Allow the appliance to stand for 4 hrs after installa-
tion.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clockwise to a tem-
perature lower than << - 16 °C >> position.
4. The Green On/Off Indicator Light will light up and Red
Alarm Indicator Light will blink.
5. The lighting up of the Green On/Off Indicator Light
means that the appliance is switched on.
6. The blinking of the Red Alarm Indicator Light means
an improper temperature in the freezing compart-
ment. In addition, an intermittent sound can be heard,
which can be stopped by pressing the Acoustic Signal
Stop and Fast Freeze Switch once.
7. When switching on the freezer for the first time, the
Red Alarm Indicator Light will blink until the internal
temperature has reached a level required for the safe
conservation of frozen food.
Switching off
1. To turn off the appliance, turn the Temperature Reg-
ulator to the "O" position.
discarded together with the urban refuse and rubbish. The
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol
3
4
2. To disconnect the appliance from the power discon-
nect the mains plug from the wall socket.
Temperature regulation
The temperature within the appliance is controlled by the
Temperature Regulator situated on the control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature Regulator toward higher settings
to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Red Alarm Indicator Light
Under normal operating conditions, the internal temper-
ature of the freezer will ensure the long-term conservation
of the stored food.
When such temperature rises above a certain level (-12
°C), the appliance will trigger an acoustic and light alarm.
The light alarm is a blink red light (Red Alarm Indicator
Light), while the acoustic alarm is an intermittent sound.
are recyclable.
5
15

Publicidad

Tabla de contenido
loading

Tabla de contenido