Cisco 350X Serie Guia De Inicio Rapido página 5

Repeat
S 3
TEP
connect to the switch.
A category 6a and higher cable is required for 10G ports; a category
N
OTE
5e or higher cable is required for all other ports. When you connect your
network devices, do not exceed the maximum cabling distance of 100
meters (328 feet). It can take up to one minute for the attached devices
or the LAN to be operational after it is connected. This is normal behavior.
Power over Ethernet Considerations
The switch is to be connected only to PoE networks without
W
ARNING
routing to the outside plant.
If your switch is one of the Power over Ethernet (PoE) models, consider the
following power requirement:
350 Switches with Power Over Ethernet
Model
SG350X-24P
SG350X-24MP 382 Watts
SG350X-48P
SG350X-48MP 740 Watts
*60-Watt PoE extends the IEEE Power of Ethernet Plus standard to double
the power per port to 60 Watts.
Cisco 350X Series Managed Switches
Step 1 and Step 2
Power
Dedicated
to Poe
195 Watts
382 Watts
for each device that you want to
Number of Ports
Supporting Poe
1–24
*60-Watt UPoE: ports
1, 2, 13, 14
1–48
*60-Watt UPoE: ports
1, 2, 3, 4, 25, 26, 27, 28
Poe Standard
Supported
802.3af/at
60 -Watt PoE
802.3af/at, 4 pair
PoE, Rest af/at
5