Mounting Instructions - MRA 4025066156931 Instrucciones De Montaje

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 mounting assembly (HKSW) consisting of:
2 Handlebar clamps [No. 1]
2 Handlebar clamps [No. 1]
2 Cylinder pins [No. 1]
2 Ball bars, 170 mm [No. 2]
2 Bracket clamps [No. 3]
2 Ball clamps [No. 4]
2 Covers [No. 5]
4 Oval head screws, black, M5x16 mm [No. 6]
4 Allen screws, M5x16 mm [No. 7]
8 Nuts, M5 [No. 8]
2 Allen screws, M6x55 mm [No. 9]
2 Nuts, M6 [No. 10]
2 Nut caps [No. 11]
2 Screw caps [No. 12]
2 Bar caps [No. 13]
4 Handlebar adapter, 22 mm [No. 14]
1 Edge protection strip with end sleeves
How to mount the screen on your motorbike:
1. Stand your motorbike up on a level surface.
2. Mount the HKSW bracket set onto the handlebars of your motorbike as shown in P1 and in the exploded
view. Make sure that the ball clamp [No. 4] is positioned for you to mount the nuts [No. 8] from ABOVE and
the screws [No. 7] from BELOW.
3. Do not tighten the screws yet.
4. Mount the MRA screen with the covers [No. 5] and M5 oval head screws [No. 6] and nuts [No. 8] onto the ball
clamps [No. 4].
5. Line up the MRA screen on your motorcycle with the rubber pads resting on the fairing (P2).
6. Tighten up the screws after lining up the screen to the centre.
7. Mount the edge protector strip; slide the end sleeves over the ends of the edge protector strip and gently
crimp the sleeves with a pair of pliers to secure it (P3).
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA MT 03
Article No..
--- Allen keys, 3, 4, 5 mm
10546
10547
10615
10960
10544
10543
10542
10554
10560
10557
10660
10646
10540
10548
10550
10545
---
3
Required tools