Ruwido digital_2 Instrucciones De Uso página 15

GB
Manual TV set programming
1) Switch your TV set on.
2) Look up the brand of your TV set under "TV" in the code list. Single or multiple
4 digit codes are shown for each brand.
Note
search function in the support area to enter your set model number directly in order
to obtain the appropriate code. This will save you having to test several codes.
3) Press and hold the TV Standby button (
4) Use the number keys to enter the fi rst four-digit code from the code list for the
brand that you have selected. The signal LED ( ) fl ashes twice to indicate that the
code has been accepted.
5) Test the functionality of your remote control using the TV standby button (
the AV button (
6) If the TV set does not respond, or only responds partially to the commands, repeat
steps 3 to 5 using the next code from the code list.
7) If the TV set responds properly to all functions, your digital_2 is correctly
programmed and can be used. Please note the code that was used for future
reference.
Manual programming for the satellite receiver and the DVB-T
(Freeview)/cable-box (STB)
1) Switch your satellite receiver or DVB-T (Freeview)/cable-box (STB) and TV set on.
2) Look up the brand of your unit under "STB" in the code list. Single or multiple
4 digit codes are shown for each brand.
Note
search function in the support area to enter your set model number directly in order
to obtain the appropriate code. This will save you having to test several codes.
3) Press and hold the STB Standby button (
twice.
4) Use the number keys to enter the fi rst 4-digit code from the code list for the brand
that you have selected. The signal LED ( ) fl ashes twice to indicate that the code
has been accepted.
5) Now test the individual buttons on your remote control for function, starting with the
STB Standby button ( ), volume buttons (volume
1 to 21 (in accordance with functional description table). The AV button (
TV Standby button (
6) If the unit does not respond, or only responds partially to the commands, repeat
steps 3 to 5 using the next code from the code list.
7) If the unit responds properly to all functions, your digital_2 is correctly programmed
and can be used. Please note the code that was used for future reference.
My programming codes to use:
TV
BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 15 BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 15
OPERATING INSTRUCTIONS
ruwido digital_2 universal remote control
: On our website www.ruwido-consumer.com you can use the code
).
av
: On our website www.ruwido-consumer.com you can use the code
) are not tested.
tv
STB
) until the signal LED ( ) fl ashes twice.
tv
) until the signal LED ( ) fl ashes
stb
/ ), and then with the buttons
15
) and
tv
) and
av
19.01.2011 12:29:32 19.01.2011 12:29:32