Button Lock - Ruwido digital_2 Instrucciones De Uso

GB
Code reader
The code reader can be used to display the codes that you have found in the search
process so that you can make a note of them:
1) Press and hold the TV Standby button (
until the LED Signal ( ) fl ashes twice.
2) Use the number buttons to enter the code
twice again.
3) Push
number.
4) Push
number.
5) Push
number.
6) Push
number.
Note
be carried out in any order and as many times as may be required.
Operating the volume function on the TV set or satellite receiver
or the DVB-T (Freeview)/cable-box (STB)
As standard, the volume and mute functions are operated from the satellite receiver or
DVB-T (Freeview)/cable-box (STB).
If you wish to operate these functions on the TV set, then please carry out the
following steps.
1) Press and hold the TV Standby button (
2) Use the number buttons to enter the code
again.
If you wish to operate the volume functions on the satellite receiver or the DVB-T
(Freeview)/cable-box (STB) again, carry out the following steps.
1) Press and hold the TV Standby button (
2) Use the number buttons to enter the code
again.

Button lock

You have the facility for deactivation of individual or not-required functions on the
digital_2 remote control.
1) Press and hold the STB Standby button (
twice.
2) Use the number buttons to enter the code
again.
3) Push all the buttons, one after the other, whose functions that you wish to block.
4) Push the STB Standby button (
Note
Note
remote control. See function "Deleting settings (reset)".
BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 19 BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 19
OPERATING INSTRUCTIONS
ruwido digital_2 universal remote control
and count the number of times the Signal LED fl ashes; this is the fi rst
1
and count the number of times the Signal LED fl ashes; this is the second
2
and count the number of times the Signal LED fl ashes; this is the third
3
and count the number of times the Signal LED fl ashes; this is the fourth
4
: The Signal LED does not fl ash if the number is 0. The steps 3 to 6 can
: The numbers and the Standby button ( ) cannot be blocked.
: If you want to reverse the key lock again, you need to fully reset the
) or the STB Standby button (
tv
. The Signal LED ( ) fl ashes
0 0 0 2
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED fl ashes twice
0 0 0 4
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED fl ashes twice
0 0 0 5
) until the signal LED ( ) fl ashes
stb
. The Signal LED fl ashes twice
0 0 0 6
) to confi rm.
stb
19
)
stb
19.01.2011 12:29:52 19.01.2011 12:29:52