Programming Dose Of Coffee - Ascaso BABY T Manual De Usuario

10 – Programming dose of coffee
To programme the amount of coffee, with the machine on and ready to make coffee
(keys of the keypad permanently lit), press the programming button XL for 5 or 6
seconds until it is lit intermittently while the rest of the keys are illuminated in a fixed
manner in pale blue. Then follow the steps given below:
1. Click on the section you want to programme. The machine will start operating.
Important! Each of the S and L keys has two selections, depending on whether
you press them once or twice. When programming, you should follow the same
process: if you press the keys once, you programme the single selection (the key
lights up in white during the volume adjustment), and if you press the keys twice,
for a double selection, the key turns blue during the volume adjustment.
2. Press the key once again as soon as you have reached the desired volume to stop
it at that point.
IMPORTANT! So you know which selection has been set on each key, take a look
at the colour of the key. If it is pale blue, it means you have not set either of the two
selections. If it is dark blue, it means you have set the single version. When you
have set the two selections of a key, the illumination will disappear to show that the
settings have been completed.
3. Once you have set the dose, to finish the process press the XL key – the S and L
keys will then turn white.
4. Press the XL key twice to go back to the operating mode of the machine.
Important! If, instead of this last step, you press the S or L key, it may change the
machine's configuration. If this happens and the machine does not work properly
(e.g. the pump is not activated), repeat the settings process and complete it
correctly, or do a machine reset.
MANUAL BABY T ENG-ESP_DE 2020 .indd 17 MANUAL BABY T ENG-ESP_DE 2020 .indd 17
1 large continuous
1 small coffee
coffee (press again
to discontinue
the dose)
17
22/09/2020 16:29:13 22/09/2020 16:29:13