Seca 334 Manual De Instrucciones página 7

Auto hold function
For weights above 0.4 kg, the HOLD func-
tion is activated automatically. The display
flashes until a stable weight has been
measured. The display is then frozen until
the next weighing operation takes place.
HOLD appears in the display.
Automatic shut-down/power-saving
mode
To save power, the scale switches itself off
after a short time if there is no load on it.
Switching the weight display
Switch on the scale. Weight is initially dis-
played in the last setting used, either in kilo-
grammes or pounds.
To switch the weight display between kilo-
grammes and pounds, press the kg/lbs
key.
Taring weight display (TARE)
The tare function is useful if an additional
weight (for example a cloth or pad on the
weighing surface) is to be ignored in the
weighing result. Proceed as follows:
press the TARE key while the additional
weight is on the scale and wait until
appears in the display.
Important!
The maximum weight which can be dis-
played is reduced by the weight of the ob-
jects already placed on the scale.
You can now perform as many weighing
operations as you like with this additional
weight.
You can switch off TARE by pressing the
TARE key again or by switching off the
scale.
Use of differential display function
You can use this function for example to
measure the intake of milk when breast-
feeding or have Baby's increase in weight
displayed since being last weighed. This
function can be used to store an individual
weight value and then use that value to form
a difference - to detect the amount of milk
ingested during breastfeeding, for example,
or to see how a particular baby's weight
has increased since it was last weighed.
– To store the weight value, press the
STORE key for approx. 2 seconds after
the weighing operation is complete. The
ST0
indicator is faded in. The weight val-
ue is now saved and will also remain
stored once the scale is switched off.
– With a subsequent weighing operation it
0. 0 00
is then possible to switch the display
over to differential display, i.e. display of
current value less saved value, by briefly
pressing the STORE button.
When the differential display function is
activated, appears in the display.
– Briefly pressing the key again switches
the function off again.
Note:
If a new weight value is stored, the previous
stored value will be overwritten.
If the differential display function is activated
with no load on the scale, the stored value
is shown in the display as a negative value.
Cleaning
Clean the weighing tray and the housing as
required using a domestic cleaning agent or
a commercially-available disinfectant. Fol-
low the manufacturer's instructions.
What do I do if ...
... no weight is displayed when there is
a weight on the scale?
Is the scale switched on?
Check the batteries.
0. 0 00
... does not appear before weigh-
ing?
Switch the scale off and back on again,
making sure there is no load on the scale.
... appears in the display?
Battery power is dropping. Change the bat-
teries in the next few days.
bAtt
... appears in the display?
The batteries are completely discharged.
Insert new batteries.
St0p
... appears in the display?
The maximum load has been exceeded.
7