HyperIce Normatec 2.0 Instrucciones De Operación página 10

ADJUST THE REST TIME
To enter rest time edit mode, set the time to 10 minutes then hold down the time adjustment button for four seconds
(until the blue rest time indicator lights up and begins blinking). When in rest time edit mode, the rest time will blink on the
screen. Use the and time adjustment buttons to increase or decrease the rest time. The rest time can be set between
15 and 90 seconds in 15-second increments. The default rest time is 30 seconds. To save and exit rest time edit mode, tap
the play/pause button on the control unit.
CHANGE THE MASSAGE PATTERN
The massage pattern can be set to the patented NORMATEC PULSE or SEQUENTIAL. If the control unit is set to
SEQUENTIAL mode, it will be displayed under the session time. To enable and disable the SEQUENTIAL massage
pattern, set the control unit to Level 7 and then hold the level button for five seconds.
PATENTED NORMATEC PULSE MASSAGE PATTERN
Before the patented NORMATEC PULSE massage pattern begins, you will experience a pre-inflate cycle, during which the
connected attachments are molded to your exact body shape. Once the pre-inflate cycle is complete, the patented NORMATEC
PULSE massage pattern will begin by compressing your feet, hands, or upper quad (depending on which attachment you are
using). Similar to the kneading and stroking performed during a massage, each zone of the attachments will first compress in
a pulsing manner and then release as the compression pattern works its way up your limb. When the top zone completes its
massage, there will be a brief rest period and then the cycle will begin again. This will repeat until the session time runs out.
When the session is resumed after a pause, the system will perform a pre-inflate cycle before continuing.
SEQUENTIAL MASSAGE PATTERN
The SEQUENTIAL massage pattern begins by compressing your feet, hands, or upper quad (depending on which
attachment you are using). Each zone of the attachments will compress and hold pressure. This will repeat for each zone
of the attachments as the compression pattern works its way up your limb.
ADJUST THE NUMBER OF ZONES
The number of attachment zones enabled can be changed between one and five zones. Zones can be disabled from the
top to the bottom of the attachment, one zone at a time. Zone adjustments do not reset after powering off the control unit.
To enter zone edit mode, set the control unit to Level 1 and then hold the level button for five seconds. The top-most
enabled zone of the attachment will begin blinking. When in zone edit mode, the top enabled zone on the screen's
attachment graphic will blink. Use the and buttons on the control unit to increase or decrease the number of enabled
zones. At least one zone must be enabled. To save and exit zone edit mode, tap the play/pause button on the control unit.
The top-most enabled zone will stop blinking.
10