HyperIce Normatec 2.0 Instrucciones De Operación página 8

• Step 2: Connect the hose connector to the air outlet on the Normatec 2.0 control unit. The connector can only be inserted
in the correct orientation. Insert the connector firmly into the Normatec 2.0 control unit until you hear an audible "click."
• Step 3: Put the leg, arm, or hip attachments on. Find a comfortable position sitting, reclined, or lying down. If the
attachments have a zipper, be sure to zip up the attachments completely. Never try to use the system with the zipper
partially or totally unzipped—this could void your warranty. Only one set of attachments can be used with a single
control unit. When using more than one attachment, make sure they are both of the same type.
• Step 4: Connect the attachment connectors on each attachment to the junction box air outlets. The attachment
connectors can only be connected to the junction box in the correct orientation. Insert the attachment connectors
firmly into the junction box air outlets until you hear an audible "click."
If only one attachment will be connected to the junction box, use the blocking plug located on the underside of the
junction box to block off the unused junction box air outlet. Press firmly to make sure the blocking plug is fully seated.
• Step 5: Press the power button on the Normatec 2.0 control unit firmly for one second to turn on the system. While
the control unit is on, the green LED next to the power button will be lit up.
ADJUST THE INTENSITY
Adjust the intensity level of the session by pressing the level adjustment buttons on the left and right of the level indicator.
Intensity level 1 is the gentlest setting. The massage becomes stronger as the intensity level is increased. Intensity can be
adjusted while the session is running. When level is adjusted during a session, the system will stop for 10 seconds, and the
cycle will resume at the new pressure.
ADJUST THE SESSION TIME
Adjust the session time by pressing the time adjustment buttons on the left and right of the time indicator. The session
time can be set between 10 minutes and 2 hours and 55 minutes (in 5-minute increments). A typical session time is
between 15 and 60 minutes long. Setting the time longer than 2 hours 55 minutes will put the control unit into Continuous
Mode. To turn off Continuous Mode, decrease the time. In Continuous Mode, the screen will display CONTINUOUS
instead of the timer and will begin counting up from zero when the session starts. Time can be adjusted while the session
is running. Tap the time adjustment buttons to add or subtract time from the session in 5-minute increments.
TURN OFF BLUETOOTH WIRELESS TECHNOLOGY
To disable Bluetooth wireless technology on the device, press and hold the Bluetooth button on the top of the device for
ten seconds. The Bluetooth icon will disappear from the screen when it is disabled.
START THE SESSION
To start the session, tap the play/pause button.
8