Replacing The Lamp; Installation - AEG SCT51800S0 Manual De Instrucciones

Problem
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.

6.1 Replacing the lamp

1
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The temperature regula-
tor is not set correctly.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
2
Solution
Set a lower temperature.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
1. Switch off the appliance.
2.
Press on the rear hook and at the
same time slide the cover in the di-
rection of the arrow.
3. Replace the lamp with one of the
same power and specifically de-
signed for household appliances.
(the maximum power is shown on
the lamp cover).
4. Slide the lamp cover into its original
position.
5. Switch on the appliance.
6. Open the door. Make sure that the
light comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ENGLISH
31