Technical Description (Component And Interfaces) - Dentsply Sirona inLab MC X5 Manual Del Operador

3 General information on the device

3.3 Technical description (component and interfaces)

12
Technical description (component and
3.3
interfaces)
The suction devices are intended for operation on the inLab MC X5 and
CEREC MC/MC X/MC XL Premium Package/Primemill processing
machines. The suction system is equipped with a special filter bag and
a HEPA micro filter of filter category H12, which filters fine dust up to
99.5% and is classified as fine dust category M.
A Socket for suction tube
B Control panel
C Maintenance flap
D Socket for interface cable
Check the device for any transport damage immediately after
unpacking. If there is transport damage, raise this with your supplier
immediately.
Dentsply Sirona
Operating Instructions for suction devices
E On/Off switch
F Socket for power cable
G Suction power control
H Device safety switch
64 98 609 D3608
D3608.201.02.05.02 10.2020