Connecting The Suction Device; Connecting The Suction Tube - Dentsply Sirona inLab MC X5 Manual Del Operador

4 Transportation and installation

4.4 Connecting the suction device

16
Connecting the suction device
4.4
4.4.1

Connecting the suction tube

A
1. Connect one end of the suction tube to the available connection
point (A) on the suction device. The connection point is located on
the top side next to the control panel with the suction power
controller.
2. Connect the other end of the tube to the socket (B) on the rear side
of the processing machine. The figure shows an example of a
connection to the CEREC Primemill processing machine.
CAUTION
Trip/fall hazard
If the suction tube is routed poorly, there may be a risk of tripping.
➢ To prevent injuries caused by tripping, route the suction tube so
that there is no risk of tripping.
Notes on the suction tube:
The suction tube is supplied with a length of approx. 2.40 m (inLab MC
X5) or 2.0 m (CEREC MC/MC X/MC XL Premium Package/Primemill).
When connecting the suction device to the unit, please ensure that no
sharp bends occur over the full length of the suction tube.
Reduce the length of the tube according to your requirements and your
installation location. Note that suction power drops along the length of
the tube. You obtain decent suction power if the suction device is
placed immediately below the machine and you have a tube length of
1.20 m or less.
Dentsply Sirona
Operating Instructions for suction devices
B
64 98 609 D3608
D3608.201.02.05.02 10.2020