Remote Control Unit; Inserting Batteries; Using The Remote Control Unit - Denon Professional DN-V200 Instrucciones De Operación

Ocultar thumbs Ver también para DN-V200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6 REMOTE CONTROL UNIT

2 The DN-V200/DN-V300 can be controlled from a distance using the included remote control unit (RC-963).

(1) Inserting Batteries

q Remove the remote control unit's rear cover.
w Place two R03/AAA batteries in the battery compartment in
the direction indicated by the marks.
e Close the rear cover.

(2) Using the Remote Control Unit

Approx.
7 meters
30°
30°
Cautions On Batteries
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once a
year, though this depends on the frequency with which the
remote control unit is used.
• If the remote control unit does not operate from close to the
main unit, replace the batteries with new ones, even if less
than a year has passed.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in the
proper direction, following the < and > marks in the remote
control unit's battery compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• Remove the batteries when not planning to use the remote
control unit for a long period of time.
• If the batteries should leak, carefully wipe off the fluid from
the inside of the battery compartment, then insert new
batteries.
• When operating the remote control unit, point it at the
remote control sensor as shown on the diagram.
• The remote control unit can be used from a direct
distance of approximately 7 meters. This distance will be
shorter, however, if there are obstacles in the way or if
the remote control unit is not pointed directly at the
remote control sensor.
• The remote control unit can be operated at a horizontal
angle of up to 30° with respect to the remote control
sensor.
NOTES:
• It may be difficult to operate the remote control unit if
the remote control sensor is exposed to direct sunlight
or strong artificial light.
• Do not press buttons on the main unit and on the
remote control unit at the same time. Doing so will
result in malfunction.
ENGLISH
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dn-v300

Tabla de contenido