Chicco Hook on Chair Instrucciones De Uso página 8

H C
OOK ON
GB
The instructions contained in this booklet also apply to the
CADDYLINE version.
WARNING
• WARNING: Never leave your child unattended.
• Age range: from around 6 months up to babies of 15 Kg.
• Only use with babies able to take up a correct and
independent sitting position.
• Do not use on glass, crystal or similar table surfaces, or
rough or uneven surfaces, tables with a single leg, games
or camping tables. Do not use on table extensions.
• Do not fi x the table seat in places where the baby
could use its feet to push against the table, chairs or
other structures causing the seat to shift and become
unstable.
• Before using always make sure that the joints are
securely screwed to the table.
• Do not hang objects on the seat which could make the
seat unstable.
• Do not fi x or unfi x the seat with the baby inside.
• Do not use the seat with more than one baby at a time.
• Do not let other children play unattended close to the
seat.
• Do not use or leave table cloths or other objects on the
table surface which could interfere with the components
which fi x the seat to the table. Keep the table surface
clean and dry.
• Check the table is stable when the seat is fi xed in place.
• The table top must have a minimum thickness of 19 mm.
and a maximum of 38 mm.
• Frequently check that the fi xing pins are screwed in
securely and tighten if necessary.
• WARNING: do not use the seat if parts are broken,
damaged or missing.
• Do not use spare parts not supplied by the
manufacturer.
• WARNING: Keep all plastic bags out of reach of the child
to avoid the risk of suffocation.
ASSEMBLY
Join the two arms (diag. A) to the table seat frame. Proceed
as follows: Join the arm with the red symbol to the side of the
seat (diag. B) with the red arrow (as shown in diag. 1). Connect
the arm and ensure that that both of the pins are locked into
position (diag. 2). A double click will indicate that the pins are
locked correctly into position. Repeat the operation on the
other arm. Fix both the cover fastenings with the automatic
studs by passing them around the frame (Fig. 3). Make sure the
upper stud is used. Check that the fabric armrests are correctly
fi xed to the lower catches (Fig. 4) (no Caddy). These are situated
immediately below and in line with the catches indicated in
the previous operation above. It is possible that the two arms
inserted remain "open", in the ready-for-use position. If you do
not wish to use the product immediately, just press the "pins"
shown in fi g. 5, on both sides to close the arms.
HOW TO USE
Open the two arms (Fig. 6) and make sure that they are
securely fi xed in an open position by trying to close them.
Press the catches on the lower joints and push the pins in a
downward direction (Fig.7). Incline the table seat by raising the
rear section and position it on the table surface (Fig.8). Push
All manuals and user guides at all-guides.com
HAIR
until it comes to a halt (Fig.9).Push the joint pin upwards until
it makes contact with the table surface (Fig.10/10A). Repeat
this operation with the other joint.Make fi nal adjustments
by rotating the handgrips situated under the joints in an
ANTICLOCKWISE direction, until the seat is securely fi xed (Fig.
11). Repeat this operation with both the handgrips. Check they
are securely fi xed by pushing the seat away from the table.
Unfasten the double safety belt and seat the child (Fig. 12).
Fasten the safety belt by passing it through the crotch strap.
Do not place chairs or similar objects under the table seat while
in use. Detach the seat from the table only after removing the
child. To remove the table seat from the table, turn the knob
in a CLOCKWISE direction until the initial position is reached.
Then press the buttons on the joints and the locking pins will
unlock automatically. If necessary, exert gentle pressure on the
knobs.
REMOVABLE LINING
Unfasten the catches of the cover (Fig.13).
Unfi x the two arms by pressing the two pins on both sides
(Fig.14/14A).
Unfasten the waist harness from the "D" rings and pass them
inside the fabric. At this point it is possible to remove the cover
from the frame. Repeat the operation in reverse to replace the
cover, being careful that the harness passes through the "D"
rings correctly (Fig.15).
WASHING INSTRUCTIONS
Release the fastening at the centre of the seat and pull out
the rigid base (Fig.16). Follow the instructions on the label
carefully. After each washing check the condition of the fabric
and the seams.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE ADVICE
• Periodically check the seat for possible broken parts, damage
or missing parts. In such cases do not use the seat.
• Dry the metal parts carefully to avoid rusting.
FOR FURTHER INFORMATION, PLEASE CONTACT:
Chicco UK Ltd
Prospect Close
Lowmoor Road Business Park
Kirkby in Ashfi eld
Nottinghamshire NG17 7LF
Customer Services Helpline Tel: 01623 750870
(offi ce hours only)
www.chicco.com
8