Rm100 Remote Control; Power Supply - GeoMax Zoom3D Manual De Usuario

2.3.2

RM100 Remote Control

Remote Control Compo-
nents
Navigation Buttons
2.4

Power Supply

First-time Use /
Charging Batteries
Operation / Discharging
Zoom3D Power Supply
Description of the System
a b c d e
1 0 0
R M
011280_001
The RM100 Remote Control has five buttons that allow turning the Zoom3D and executing a distance
measurement or point projection, depending on the application program running.

The RM100 Remote Control does not support the Tool Kit applications.
Targeting Procedure
1) Rough targeting: hold
2) Fine targeting: short tap on
3) Measure: Press .
• The battery must be charged prior to using it for the first time because it is delivered with an energy
content as low as possible.
• The permissible temperature range for charging is between 0°C to +40°C/ +32°F to +104°F. For
optimal charging, we recommend charging the batteries at a low ambient temperature of +10°C to
+20°C/+50°F to +68°F if possible.
• It is normal for the battery to become warm during charging. Using the chargers recommended by
GeoMax, it is not possible to charge the battery if the temperature is too high.
• For new batteries or batteries that have been stored for a long time (> three months), it is effectual
to make only one charge/discharge cycle.
• For Li-Ion batteries, a single discharging and charging cycle is sufficient. We recommend carrying out
the process when the battery capacity indicated on the charger or on a GeoMax product deviates signif-
icantly from the actual battery capacity available.
• Batteries can operate from -10°C to +50°C/14°F to +122°F.
• Low operating temperatures reduce the capacity that can be drawn; high operating temperatures
reduce the service life of the battery.

Only GeoMax authorised service workshops are entitled to replace the battery socket.
• Internal: by battery socket, with non-removable Li-Ion batteries, 14.4 V, 63 Wh.
• External: Power supply for Zoom3D connected by cable with country-specific plugs for worldwide use.
Input: 100 - 240 V AC, 50/60 Hz.
Output: 24 V DC, 2.5 A.
Length: 1.80 m.
010761_001
a) Key ring
b) Battery compartment
c) DIST button
d) Navigation buttons: Up/Down/Right/Left
e) Control LED
/ / / to turn the Zoom3D as long as key is pressed.
/ / / to turn the Zoom3D by small single steps.
a
b
a) Battery socket
b) Power supply connector
Zoom3D | 12
en