interior
28/4/04
• If the cable becomes damaged, have it
replaced by an authorised Technical
Assistance Service.
• Do not use any electrical appliance if the
cable or plug are damaged, if it is not
working properly or if it is damaged in any
way. Take it to an authorised Technical
Assistance Service to be examined,
repaired or modified.
• In the event of technical failure or improper
working, switch the machine off and do not
try to repair it. Repairs should only be
carried out by an authorised Technical
Assistance Service. Always demand the
use of original spare parts.
• If you decide never to use the appliance
again, it is a good idea to cut the cable,
first ensuring that the appliance is
unplugged.
The liquid that drips into the jug is hot and
may cause burns if the jug is accidentally
broken. To avoid breakage, take the
following safety precautions:
• Do not allow all the liquid to evaporate. Do
not heat the jug when empty.
• Do not use a broken jug or a jug whose
handle is loose or weak. Replace if any
signs of damage are detected. A tiny crack
or breakage of a small piece of the glass
may cause the jug to shatter and to
contaminate the liquid with splinters of
glass.
• Do not clean the jug with an abrasive
scourer or any cleaning products that may
scratch or otherwise weaken the glass.
• The jug is designed for use with this
appliance. Do not place it on or near hot
surfaces (heaters, burners, hobs, hot
ovens, microwaves, etc.).
• Do not place the jug on wet or cold
surfaces.
• Handle gently and avoid knocking.
17:21
Página 9
4. BEFORE USING FOR
THE FIRST TIME
• Before using for the first time, familiarise
yourself with all the components. Read all
instructions carefully.
• Remove the filter-holder (6) (fig. 2) and the
jug lid (7) (fig. 3) and clean along with the
jug (8) itself, the permanent filter (3) and
with the support of anti-drip valve (4) in
warm soapy water. Dry thoroughly and
replace, fitting the anti-drip valve support
into the filter-holder (fig. 4)
• To clean the inside of the appliance, run a
coffee-making cycle twice without adding
ground coffee to the filter. To do this, follow
the instructions given in the section
entitled "Making coffee".
5. MAKING COFFEE
With the appliance unplugged:
• Place the coffeemaker on a flat, stable
surface.
• Open the deposit lid (1) and make sure
that the deposit is empty. Fill with clean,
cold water to the required level. Do not
exceed the indicated maximum level mark.
• Fill the filter (3) with the required quantity
of ground coffee and close the lid. We
recommend one dessertspoon of coffee
per cup. After using the coffeemaker a few
times, you may wish to adjust the amount
of coffee used according to individual
taste.
• Make sure the lid of the jug (6) is properly
fitted, and place the jug (7) on the heater
plate (8). Ensure that the jug lid opens the
anti-drip valve (5), otherwise the filtered
coffee will not drip down into the jug and
will overflow from the filter.
• Plug the appliance into the mains and
press the start/stop switch (9). The switch
pilot light will indicate that the appliance is
ON.
• Water will begin to filter down through the
coffee into the jug. When the filtering
10