Optional Programming - Nice neomat Instrucciones Y Advertencias Para El Instalador

4.3) Optional programming

Optional programming operations can only be performed after the "0" and "1" positions have been programmed
4.3.1) Memorising the intermediate position "I"
If an intermediate position "I" has been memorised, the awning can be moved to the programmed position by simultaneously pressing keys
and on the transmitter.
To memorise the intermediate position proceed as follows:
Table "A4" Programming the intermediate position "I" (fig 10)
1. Using keys
to memorise as "I".
2. Press and hold down (approx. 5 seconds) key
3. Release and then press again key
4. Press keys
been memorised.
4.3.2) Programming RDC torque reduction during the closing operation
Torque reduction is a programmable function that decreases motor torque by approximately 50% just before the awning closes completely,
to prevent excessive stretching of the fabric.
Table "A5" Programming the RDC torque reduction function (fig 11)
1. Press and hold down key
(approx. 5 seconds).
2. Release and then press again key
3. Press key
4.3.3) Erasing the positions or the RDC function
To modify the previously memorised positions, first you need to erase them, then you must reprogram the new positions.
Table "A6" Erasing intermediate position "I" (fig 10)
1. Press and hold down key
(approx. 5 seconds).
2. Release and then press again key
3. Press keys
has been erased.
Table "A7" Erasing positions "0" and "1" (fig 12)
1. Press and hold down key
(approx. 5 seconds).
2. Release and then press again key
3. Press key
!
WARNING: After positions "0" and "1" have been erased, the awning will only move by manual control, therefore a
new position must be memorised.
Note: if you have programmed an intermediate position "I" and the RDC function, these will not be erased. If you wish to erase all (including
the transmitter codes) see table "A9."
Table "A8" Erasing the RDC torque reduction function (fig 11)
1. Press and hold down key
(approx. 5 seconds).
2. Release and then press again key
3. Press key
Note: Now the awning will close at full power
on a remote control, move the awning to the position that you wish
for 5 more seconds until you hear 4 short beeps.
and simultaneously until 3 beeps signal that the position has
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps.
until 3 beeps signal that the RDC function has been activated.
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps.
and simultaneously until 5 beeps signal that the intermediate position
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps.
until 5 beeps signal that positions "0" and "1" has been erased.
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps.
until 5 beeps signal that the RDC function has been deactivated.
until you hear the beep.
GB
Example
5s
5s
5s
Example
5s
5s
5s
Example
5s
5s
Example
5s
5s
Example
5s
5s
5