Haier HDY6-1 Manual Del Usuario página 17

4-Wire Cord Connections
green ground screw
green neutral
ground wire
red
power cord
1. Remove the screws securing the terminal block access cover and the strain
relief mounting bracket located on the back of the dryer upper corner.
2. Install a U.L. approved strain relief into the power cord entry hole of the
mounting bracket. Finger tighten the nut only at this time.
3. Remove the green neutral ground wire fom the green ground scrcew located
above the terminal block.
typical conductor
receptacle
typical 4
conductor cord
30 AMP NEMA 14-30 TYPE SRDT OR ST
green power cord
ground wire
strain relief
mounting bracket
silver terminal
terminal block
black
tighten nut to
white
these threads
nut
black 240V
white neutral
red 240V
green ground
English
16