Tabla de contenido
Publicidad
ASSEMBLING STAND
1. Attach the rubber feet (H) Fig. 11 to the bottom of
each leg (F).
Locate the two legs (F) which have holes at the
bottom for attaching the wheel brackets (G) and
brace (E). (Make sure wheels and brackets are
properly oriented. See inset Figure 12). To attach
the brackets, remove the nuts from the bolts and
insert the bolts through the holes in the bottom of
the two legs and into the holes in brace (E). Thread
the nuts back on the bolts and tighten. Assemble
the stand as shown in Fig. 11, using 16
M8x1.25x20mm carriage head bolts, 3/8 inch flat
washers and M8x1.25 hex nuts. Align the holes in
the stand legs (F) with the holes in the brackets.
Insert the carriage head bolt through the hole in the
leg and the hole in the bracket, place a flat washer
on the carriage head bolt and thread a hex nut onto
the carriage head bolt. Repeat this process for the
15 remaining holes in the legs and brackets.
NOTE: Loosely tighten the hardware for further
adjustment.
Letters are on the stand brackets to ease assembly:
A - Top front and rear brackets
B - Top side brackets
C - Bottom side brackets
D - Bottom front and rear brackets
E - Bottom brace
NOTE: Each rubber foot is provided with holes for
mounting the stand to the floor surface if required.
SAW TO STAND
1. Turn saw table face down on a piece of cardboard
to protect the table surface. Place stand upside
down onto saw and align the four holes in the stand
with the mounting holes in the saw.
2. Place a 3/8 inch flat washer on a M8x1.25x45mm
hex head screw. Insert the hex head screw through
the mounting hole in the saw and the mounting hole
in the stand. Place another 3/8 inch flat washer on
the hex head screw and thread a M8x1.25 hex nut
on the screw and loosely tighten. Complete this
process for the other three holes.
3. Stand the saw upright, as shown in Fig. 13 (Saw is
shown fully assembled here).
4. Push down on top of the saw so that the legs of the
stand adjust to the surface of the floor. Tighten all
hardware securely.
C
G
E
Wheel
11
A
D
Fig. 11
Fig. 12
Fig. 13
B
F
H
Publicidad
Tabla de contenido
