Assembly - BLACK&DECKER BDTS200 Manual De Instrucciones

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
(None supplied)
* Phillips head screw driver
ASSEMBLY TIME ESTIMATE - 1 hour
ELEVATING AND SUPPORTING SURFACES FOR A SAW WITH NO STAND
WARNING:
THE SAW MUST BE PROPERLY SECURED TO A SUPPORTING SURFACE. ALSO, FAILURE TO
PROVIDE A SAWDUST FALL-THROUGH AND REMOVAL HOLE WILL ALLOW SAWDUST TO BUILD UP AROUND
THE MOTOR, CAUSING A POSSIBLE FIRE HAZARD AND/OR MOTOR DAMAGE.
WARNING:
DISCONNECT MACHINE FROM POWER SOURCE.
The saw must be elevated enough for sawdust to fall
through the bottom of the saw and not build up around
the motor.
Position the four mounting holes located on the base of
the saw cabinet (two of which are shown at (A) Fig. 4A)
over whatever proper support you are using. Then
securely fasten the saw to the supports. The saw can
be secured by fastening the stand through the mounting
holes with suitable hardware (not supplied).
WARNING:
THE SAW SUPPORT MUST BE STABLE
AND ABLE TO SUPPORT 300 POUNDS.
You can also construct a simple elevated support, as
shown in Fig. 4B.
WARNING:
USE A GOOD GRADE OF PLYWOOD
WITH A MINIMUM 3/4 INCH THICKNESS. DO NOT
MAKE THE MOUNTING BOARD FROM PARTICLE
BOARD SINCE PARTICLE BOARD BREAKS EASILY.
WARNING:
A HOLE MUST BE PROVIDED IN THIS
SUPPORT TO ALLOW SAWDUST TO FALL
THROUGH.
Square the saw on the supporting surface and mark the
location for four 5/16 inch holes to be drilled (Fig. 4B).
WARNING:
MAKE SURE THERE IS AT LEAST 3
INCH ON ALL FOUR SIDES OF THE
BASE.
Set the saw aside and then drill holes in these marks.
Locate and mark an 11 inch or 12 inch square centered
between the four mounting holes. Cut out and remove
the square (Fig. 4B). To elevate the supporting surface,
measure two 2x4s (A) Fig. 4B to the width of two
opposite sides of the supporting surface. Attach the
supporting surface to the narrow edges of the 2X4s (as
shown in Fig. 4B) using wood screws (not provided) in
at least three spots (B) Fig. 4B on each side.
Fasten the saw to the surface by inserting suitable
hardware (not supplied) through the mounting holes on
the saw and into the previously drilled holes. While
using the saw, periodically remove the sawdust buildup
from below the saw.
* 13mm wrench for stand bolts
* 10mm wrench for splitter assembly bolts
* Straight edge and/or framing square for adjustments
5/16" PILOT
SAW PLACEMENT HOLES
MARKS
B
9
A
Fig. 4A
B
A
Fig. 4B