Kenmore 116.30412 Manual Del Propietário página 18

NOTE: See PARTS AND FEATURES for
belt number.
Loop the other end of the belt on the belt
pulley on the agitator.
Insert the agitator by placing the rounded
portion of the end cap down into the slot
in the nozzle base,
NOTE= It may be necessary to hold the
furniture guard out of the way in order to
allow proper insertion of the agitator into
the nozzle base,
Agitator Nozzle
Base
Furniture Base
Guard End Slot
Cap
NOTE= Care must be taken due to the
belt tension during reassembly.
Press firmly,
checking to
see that
each end is
completely
inserted.
Check to see that the belt is centered on
the belt pulley. Turn the agitator with your
fingers to see that it turns freely°
To re-attach
the agitator
_
cover, insert
the six (6)
tabs into the _-.._;_
six slots
along the
front edge of
the nozzle
Tabs/
base.
Slots
Locking
Tabs
Lower the agitator cover to its original
position, After positioning the agitator
cover, push forward on the two (2) locking
tabs in order to ensure that they are
securely in place.
Re-fasten
the furniture
guard retain-
ers to the
posts on
both sides of
the agitator
cover.
Agitator
Cover
Furniture
Guard
Retainer
NOTE: If the agitator cover is not installed
correcly, you may experience a toss of
performance and possible agitator vibra-
tion, etc.
Headlight
Lock Tabs
_ Securely ln _
lJ It1[ Place _- _
Make sure the headlight wires are tucked
securely in place.
Replace the
nozzle cover
and
secure
the latches.
Nozzle
Cover
18