Handle Assembly - Kenmore 116.30412 Manual Del Propietário

E
WARNING
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete,
Failure to do so could result in elec-
trical shock or injury.
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List, Use this list to verify that
you have received all the components of
your new Kenmore vacuum°
Remove the tape located below the dust
covedfilter cover on the motor case_
Tape
Attach
stretch hose
end to noz-
zle as
shown.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum°
Position the handle as shown in the illustra-
tion below.
Slide the handle into the opening at the top
of the vacuum.
Insert the screw so it passes through the
handle into the vacuum_
Begin to tighten the screw with your finger&
it may be necessary to adjust the handle
slightly_