iGuzzini LMS QUICK Manual De Instrucciones página 105

You can also select the full page display mode.
Finally, you can decide whether to display/print the contour lines of the template and buttons.

RECOMMENDED PROCEDURE TO CENTRE THE PRINT
First, print a white sheet and make sure you:
- mark the sheet with an X before the print to understand the side that will be actually printed
- select the Print button reference guide option
- Measure the upper and lateral margins of the print on white sheet.
- Compare them with the margins of the Stardream sheet of the template.
- Adjust the software parameters according to the difference.
Example: the white sheet has an upper margin of 39; the margin of the Stardream sheet is 37. You must
subtract 2 from the number contained in the Upper margin box, which changes from 32 to 30 in this case.
Now:
- eliminate the Print button reference lines option
- place the Stardream sheet in the correct direction (print side)
- launch the print
It is recommended to remove the inside of the buttons delicately before the print and detach the printed
template with scissors or a cutter in the connection points.
102