Frequently Asked Questions - Fagor FET-6412WS Manual De Instrucciones

4 / PROGRAMMING YOUR MACHINE
•DETAILS OF THE PROGRAMMES
•Flash 30min
This programme enables you to refresh a small load of 2.5 kg of
lightly soiled washing composed of WHITES, COTTONS,
COLOUREDS or HARD-WEARING SYNTHETICS.
The cycle time is restricted to around 30 minutes
In this programme, the washing temperature is automatically programmed
at 40°C.
Important :
For this programme, the doses of detergent should be
reduced by half
• Empty tank
Allows you to drain the "Water saver technology" tank.
N.B.: When you next run a cycle, the tank will again fill automatically
at the end of the programme.

•FREQUENTLY ASKED QUESTIONS

•How much water is saved by using the "Water saver
technology"?
You save 8.5 litres of water with each cycle, i.e. 25% or approximately
2 cubic metres per year.
•What happens if I wash clothes that are not colour-fast?
It is recommended to run the "Empty Tank" programme after the wash
cycle.
•Do I need to empty the tank when I go away on holiday?
It is not strictly necessary, however the tank can be drained using the
"Empty Tank" programme if you prefer.
•Is it still possible to clean the tank if I want to?
You can run a 90°C cotton programme with an empty machine but
with washing powder or liquid in the fabric softener compartment up
to the first indicator line.
The 90°C wash cycle will clean the drum, removing all traces of
colorants.
During the final rinse, the washing powder or liquid will be taken from
the fabric softener compartment.
At the end of this final rinse cycle, the water containing the product
will then be stored in the Water Saver tank.
Wait for at least 1 hour after the end of the cycle before emptying the
tank, to give the product time to act.
Then run an "Empty Tank" programme.
•Can commercial dyes be used to dye my clothes?
No, we strongly advise against the use of dyes in the washing machine.
•Can the water stay in the tank for several days?
Yes; the "Water saver technology" tank is protected by an anti-bacterial
treatment.
We have therefore been awarded the "Sanitized" label.
•DETAILS OF THE OPTIONS
(continued)
•Prewash
Specially designed for heavily soiled washing (mud, blood, etc.).
A specific initial agitation in cold water precedes a phase of heating to
30°C.
This agitation phase in cold water enables the particles soiling the washing
to be removed before the water is heated.
box (see the section "LOADING THE WASHING PRODUCTS").
•Reducing the time
Allows for a reduction in the cycle time according to 2 levels that can
be accessed by pressing on the button several times. Level 1, reduces
the average time by 20%. Level 2 reduces the average time by 40% for
laundry that is only lightly soiled.
•Rinse plus
"Especially for sensitive and allergic skin": adds an extra rinse to the
washing cycle.
•Easy ironing
This option washes your laundry more gently, but with an identical
washing performance. The spin speed is slower so that your laundry
creases less.
•Drip dry (
This function, for very delicate linen, enables you to remove spinning and
to pass directly to the draining of the washing machine.
•Full drum stop (
This function enables you to remove the washing from your machine
before the spin phase or to delay this phase with you washing remaining
in water to prevent creasing.
NB: When the machine stops with the drum full
of water, the "Spin" cycle progress light (
flashes and the remaining time displayed is
"00:00".
Then:
— Either you want to drain after spinning.
In this case, use the button (
for your type of washing.
The programme will end automatically.
— Or you just want to drain.
In this case, use the button
speed "
•Delayed start
You can delay the start of your programme to use off-peak electricity or
to avoid your washing standing in the drum for too long at the end of
the cycle.
To do this, press the button "
By repeatedly pressing the (
to delay the cycle start (in increments of 1 hour).
NB:
- The "
- The time remaining before the cycle start is counted down by the hour
until 1 hour and then by minutes from 59 minutes to 1 minute.
At the end of the waiting period, the programme starts and the machine
counts down the time remaining before the end of the cycle.
31
Important:
Detergent must be placed in the " " container in the products
)
)
)
3
to select the "Drip Dry" function (spin
").
(Retardo horario)
+
" 5 .
+
) button, select the time by which you wish
-
" button can be used to go backwards.
Information:
Throughout the whole waiting period, four elements light up in
succession
)
3 to choose a suitable spin speed
EN