English - Kenwood AT910 Manual De Instrucciones

safety
G
Pasta mix made too dry or fed
through too quickly can break your
pasta maker and/or mixer.
G
Do not place your fingers or any
other item, except the
spanner/pusher supplied, down the
feed tube.
G
Only use the spanner/pusher handle
to push dough down the feed tube.
And don't push too hard.
G
Never attach or remove the pasta
maker whilst the mixer is in
operation.
G
Feed the dough small amounts at a
time and at a steady rate. Don't
allow the feed tube to fill up.
G
Take care when handling or cleaning
as the cutting assembly blade will be
sharp.
key
hopper
feed tube
body
scroll
die*
securing nut
clamp ring of cutting assembly
cutting blade
spanner/pusher
cleaning tool
*Included in your pack is the
Maccheroni rigati die shown on the
illustration page. To purchase any of
the additional dies shown on the
back page of this booklet, please
call 0870 241 3653 or contact the
shop where you purchased the
attachment.
before using for the first time
G
Wash the parts: see 'cleaning'.
to assemble
1 Optional: for easier pasta making,
warm the body, die and ring nut in
hot water, then dry.
2 Remove the slow speed outlet
cover; slide the catch, then pull
3 Hold the catch back and insert the
pasta maker body.
4 Fit the scroll inside the body and
rotate until it engages with the
machine.
5 Fit the die.
6 Fit the securing nut and hand
tighten. (Don't use the
spanner/pusher as this is to assist
with removal only).
G
Make sure the securing nut is almost
flush against the body of the
attachment.
7 Fit the hopper.
Optional: The cutting assembly
can be fitted to the assembled pasta
maker to assist with cutting the
pasta into the desired lengths.
1 With the handle of the cutting blade
uppermost, unscrew the clamp ring
slightly. Place over the securing nut
and twist if necessary until fully
home on the attachment. The die
should fit flush with the front of the
cutting assembly.
2 Hold the edge of the cutting
assembly and at the same time
tighten the clamp ring by turning
away from you
Note – Whenever you fit or remove
the cutting assembly, always hold
the edge of the assembly in one
hand and twist the clamp ring with
the other.
2
.
.