Kenwood AT910 Manual De Instrucciones página 11

Question
The feed tube keeps blocking
The cutting assembly is difficult
to remove
The cutting assembly is difficult
to fit
Answer/Hint
G
Add small amounts of pasta at a time
in a steady rate and only add more
when the feed tube is clear.
G
The mix is too wet.
G
Use the end of the spanner/pusher to
push the mix down the feed tube.
(Removing the hopper will enable the
spanner to reach lower down the feed
tube).
G
Vary the speed of adding the mix.
G
Leave the attachment to cool down
for approximately 30 minutes.
G
Make sure the metal clamp ring is
partially unscrewed from the plastic
inner before pushing onto the
attachment.
8