Start-Up; Removing Iso-Strips; Inserting/Changing Batteries - ADE Slim Instrucciones De Operación

Symbol on the scale
The scale switch on if you press on the weighing surface with a little
force for 2 seconds.

Start-up

Removing iso-strips

The batteries are already inserted on delivery and, for protection against premature
discharge, are provided with an iso-strip. In order to start up the scale, you must
remove the iso-strips. The battery compartment is located on the underside of the
device.
− Completely remove the iso-strip protruding from the battery compartment.

Inserting/changing batteries

For use you require 2 batteries of type CR2032, 3 V.
1. Slide the battery compartment cover open to the outside.
2. Remove the old batteries.
3. Slide the batteries against the contact springs under the large, square retaining tabs
and then press them downwards. The batteries will then snap under the opposite
retaining lugs so that the batteries sit firmly in their holder.
Pay attention to the correct polarity (+/-). The plus pole (+) for both batteries must
point upwards.
4. Slide the battery compartment cover fully open again.
Notes on changing the battery:
‚ The batteries need to be changed when
the display.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always exchange all of the batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way
(see "Disposal").
Kitchen scale KE 863
Start-up
or nothing is shown on
17