Advanced Settings; Inverter Data - Ingeteam INGECON SUN 1Play HF U Manual De Instalacion Y Uso

Ingeteam
Auxiliary relay closure
Autotest
Local command

12.6.5. Advanced settings

The settings included within this menu can only be modified by a qualified installer.
Ingeteam accepts no liability for incorrect use of the installer password nor the consequences that
may arise from incorrect configuration of the unit by the user and / or the installer.
To modify the parameters of this menu the installer password will be requested.
The installer password is 3725.
Within this menu you can change the password, adjust the voltage and frequency values or modify the country and
the regulations applicable to the inverter.

12.6.6. Inverter data

From this menu you can consult different data referring to the inverter.
36
Selection of the reason the auxiliary relay closes. The selectable reasons are: insulation
fault, Vac and Fac out of range values, connected to grid or external load.
This menu is only available when the standard selected is CEI 0-21 SPI INTERNAL.
The autotest enables an automatic verification of the grid voltage and frequency limits,
bringing these limits toward the real value of the measurement and ensuring that the
unit disconnects in the set time when the measurement does not comply with the limit.
This menu is only available when the standard selected is CEI 0-21 SPI INTERNAL.
From this menu you can change the bottom and top frequency limits. These limits must
correspond to the selected standard.
ABF2013IQM01_ - Installation and Operation Manual
Display control